![]() I've simulated it in Multisim and it works perfectly. ![]() As far as I know both of these frequencies fall way less than the max frequencies for the chips (although I was unable to find a max frequency on the 7447 data sheet).īelow is the schematic. I'm using a 555 timer for my clock, the nominal frequency is 4.8 Hz (at the moment) which I plan to kick up to about 200 kHz once everything is working. The outputs to these feed into individual 7447 BCD to 7-segment decoder chips, which then go to a 3-digit common-anode 7-segment display. Meanwhile, once the clock starts, I have three 74LS190 BCD counters that load all zeros, and count up daisy-chained, so that by the time the disable is activated on the counters, it will have counted up to whatever the original 8-bit number is, and latch on to that value. they have counted down to 0), that disables all counters. When both of the counters have reached their minimum (i.e. How it works: Upon pressing a push-button, an 8-bit binary number from a DIP switch is loaded into two 74LS191 binary counters, that are wired to count down. ![]() I've created a circuit that uses both binary and BCD counters to convert an 8-bit binary number into three BCD numbers, which then feed into BCD to 7-segment decoder chips, and finally to common-anode displays.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |